How To Make Peanut Butter In A Food Processor

Do you want to know how to make peanut butter in a food processor?

Peanut butter can be widely spread on bread, toast, or crackers to make sandwiches (especially peanut butter and jelly sandwiches). It is also used in many sweets, such as peanut flavored granola rolls or croissants and other pastries.Today I will tell you how to make peanut butter in a food processor.

Before making the peanut butter,you should prepare all the necessary ingredients and equipment,including right amount of peanut, sugar, cooking oil,an oven,a food processor,a spatula and a covered container.

After preparing above things,then we can make peanut butter.The fully process can be divided into 5 step,they are all as follows.

1.Roasting the peanuts

After heating the oven to 350°F, put the peanuts on the baking tray and bake them. The peanut butter is not good, which has a lot to do with the degree of roasting. Therefore, the peanuts should be roasted until they are light golden yellow and oily for about 10 minutes. Baking gives the peanut butter a deeper taste and helps to make the oil in the peanuts looser and easier to mix into a smooth sauce.

2.Peeling the skin of peanuts

 When the peanuts are baked, remove the peanuts from the oven, let them cool, and then peel off the skin. In fact, this step can also be omitted, because the peanut skin nutrition has a high nutritional value, if you like, you can keep the skin. The peanuts that peel off the epidermis will be very white and can be baked for a while and baked until slightly discolored.

3.Grinding. 

The previously prepared food processor is then removed and the peanuts can be placed in the food processor.

Treatment for 1 minute: continuously run the food processor or blender for 1 minute. Stop and scrape off the sides and bottom of the food processor. At this point, the peanut butter looks very rough and dry.

Handle for 1 minute: Run the food processor or blender again for one minute, then stop and scrape off the sides. At this point, the peanuts were completely broken and presented in a state of peanut butter.

At this time, you can add appropriate amount of white sugar and cooking oil. This is based on personal taste. The edible oil should be tasteless or peanut-flavored. Do not add more, then continue to stir with the food processor for one minute.

 

Now you have finished all the steps and you can get the yummy peanut butter!

Above all are my introduction about how to make peanut butter in a food processor.if you have other questions,you can communicate with me!